OpenRFC.org Requests For Comments ... for the community
Welcome to OpenRFC
Home Full RFC index RFC humour Our technology
 
<< Previous <<      RFC 4091      >> Next >>    
The Alternative Network Address Types (ANAT) Semantics for the Session Description Protocol (SDP) Grouping Framework.
G. Camarillo, J. Rosenberg. June 2005.

 
[Direct link][Download PDF version][Download text version]
 

Network Working Group G. Camarillo Request for Comments: 4091 Ericsson Category: Standards Track J. Rosenberg Cisco Systems June 2005 The Alternative Network Address Types (ANAT) Semantics for the Session Description Protocol (SDP) Grouping Framework Status of This Memo This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited. Copyright Notice Copyright (C) The Internet Society (2005). Abstract This document defines the Alternative Network Address Types (ANAT) semantics for the Session Description Protocol (SDP) grouping framework. The ANAT semantics allow alternative types of network addresses to establish a particular media stream. Table of Contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . 2 1.1. Scope and Relation with Interactive Connectivity Establishment. . . . . . . . . . . . . . . . . . . . . . 2 2. Terminology . . . . . . . . . . . . . . . . . . . . . . . . . 3 3. ANAT Semantics . . . . . . . . . . . . . . . . . . . . . . . . 3 4. Preference . . . . . . . . . . . . . . . . . . . . . . . . . . 3 5. Offer/Answer and ANAT . . . . . . . . . . . . . . . . . . . . 3 6. Example . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 7. Security Considerations . . . . . . . . . . . . . . . . . . . 4 8. IANA Considerations . . . . . . . . . . . . . . . . . . . . . 5 9. References . . . . . . . . . . . . . . . . . . . . . . . . . . 5 9.1. Normative References . . . . . . . . . . . . . . . . . . 5 9.2. Informational References . . . . . . . . . . . . . . . . 5 Camarillo & Rosenberg Standards Track [Page 1]
RFC 4091 ANAT Semantics June 2005 1. Introduction A Session Description Protocol (SDP) [2] session description contains the media parameters to be used in establishing a number of media streams. For a particular media stream, an SDP session description contains, among other parameters, the network addresses and the codec to be used in transferring media. SDP allows for a set of codecs per media stream, but only one network address. The ability to offer a set of network addresses to establish a media stream is useful in environments with both IPv4-only hosts and IPv6-only hosts, for instance. This document defines the Alternative Network Address Types (ANAT) semantics for the SDP grouping framework [4]. The ANAT semantics allow for the expression of alternative network addresses (e.g., different IP versions) for a particular media stream. 1.1. Scope and Relation with Interactive Connectivity Establishment The ANAT semantics are intended to address scenarios that involve different network address types (e.g., different IP versions). They are not intended to provide alternative transport addresses with the same network type. Systems that need to provide different transport addresses with the same network type should use the SDP format defined in ICE (Interactive Connectivity Establishment) [6] instead. ICE is used by systems that cannot determine their own transport address as seen from the remote end, but that can provide several possible alternatives. ICE encodes the address that is most likely to be valid in an 'm' line, and the rest of addresses as a= lines after that 'm' line. This way, systems that do not support ICE simply ignore the a= lines and only use the address in the 'm' line. This achieves good backward compatibility. We have chosen to group 'm' lines with different IP versions at the 'm' level (ANAT semantics) rather than at the a= level (ICE format) in order to keep the IPv6 syntax free from ICE parameters used for legacy (IPv4) NATs (Network Address Translators). This yields a syntax much closer to vanilla SDP, where IPv6 addresses are defined in their own 'm' line, rather than in parameters belonging to a different 'm' line. Additionally, ICE only allows us to provide a single primary address when the peer does not support ICE. The ANAT semantics avoid relegating certain types of addresses (e.g., IPv6 addresses) to only be a secondary alternate to another address type (e.g., IPv4 addresses). Camarillo & Rosenberg Standards Track [Page 2]
RFC 4091 ANAT Semantics June 2005 Furthermore, the separation between ANAT and ICE helps systems that support IPv4 and IPv6 but that do not need to support ICE (e.g., a multicast server). 2. Terminology In this document, the key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" are to be interpreted as described in BCP 14, RFC 2119 [1] and indicate requirement levels for compliant implementations. 3. ANAT Semantics We define a new "semantics" attribute within the SDP grouping framework [4]: ANAT (Alternative Network Address Types). Media lines grouped using ANAT semantics provide alternative network addresses of different types for a single logical media stream. The entity creating a session description with an ANAT group MUST be ready to receive (or send) media over any of the grouped 'm' lines. The ANAT semantics MUST NOT be used to group media streams whose network addresses are of the same type. 4. Preference The entity generating a session description may have an order of preference for the alternative network address types offered. The identifiers of the media streams MUST be listed in order of preference in the group line. For example, in the session description in Section 6, the 'm' line with mid=1 has a higher preference than the 'm' line with mid=2. 5. Offer/Answer and ANAT An offerer using SIP [3] to send its offer SHOULD place the sdp-anat option-tag [5] in a Require header field. An answerer receiving a session description that uses the ANAT semantics SHOULD use the address with the highest priority it understands and set the ports of the rest of the 'm' lines of the group to zero. Camarillo & Rosenberg Standards Track [Page 3]
RFC 4091 ANAT Semantics June 2005 6. Example The session description below contains an IPv4 address and an IPv6 address grouped using ANAT. The format corresponding to the mapping of ICE into SDP [6] can be used in both 'm' lines to provide additional addresses. v=0 o=bob 280744730 28977631 IN IP4 host.example.com s= t=0 0 a=group:ANAT 1 2 m=audio 25000 RTP/AVP 0 c=IN IP6 2001:DB8::1 a= <ICE-encoded additional IPv6 addresses (and ports)> a=mid:1 m=audio 22334 RTP/AVP 0 c=IN IP4 192.0.2.1 a= <ICE-encoded additional IPv4 addresses (and ports)> a=mid:2 7. Security Considerations An attacker adding group lines, using the ANAT semantics, to an SDP session description could make an end-point use only one out of all the streams offered by the remote end, when the intention of the remote-end might have been to establish all the streams. An attacker removing group lines using ANAT semantics could make an end-point establish a higher number of media streams. If the end-point sends media over all of them, the session bandwidth may increase dramatically. It is thus strongly RECOMMENDED that integrity protection be applied to the SDP session descriptions. For session descriptions carried in SIP [3], S/MIME is the natural choice to provide such end-to-end integrity protection, as described in RFC 3261 [3]. Other applications MAY use a different form of integrity protection. Camarillo & Rosenberg Standards Track [Page 4]
RFC 4091 ANAT Semantics June 2005 8. IANA Considerations The IANA has registered the following new 'semantics' attribute for the SDP grouping framework [4]: Semantics Token Reference --------------------------------- ----- --------- Alternative Network Address Types ANAT [RFC4091] ANAT has been registered in the SDP parameters registry under Semantics for the "group" SDP Attribute. 9. References 9.1. Normative References [1] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, March 1997. [2] Handley, M. and V. Jacobson, "SDP: Session Description Protocol", RFC 2327, April 1998. [3] Rosenberg, J., Schulzrinne, H., Camarillo, G., Johnston, A., Peterson, J., Sparks, R., Handley, M., and E. Schooler, "SIP: Session Initiation Protocol", RFC 3261, June 2002. [4] Camarillo, G., Eriksson, G., Holler, J., and H. Schulzrinne, "Grouping of Media Lines in the Session Description Protocol (SDP)", RFC 3388, December 2002. [5] Camarillo, G. and J. Rosenberg, "Usage of the Session Description Protocol (SDP) Alternative Network Address Types (ANAT) Semantics in the Session Initiation Protocol (SIP)", RFC 4092, June 2005. 9.2. Informative References [6] Rosenberg, J., "Interactive Connectivity Establishment (ICE): A Methodology for Network Address Translator (NAT) Traversal for Multimedia Session Establishment Protocols", Work in Progress, February 2005. Camarillo & Rosenberg Standards Track [Page 5]
RFC 4091 ANAT Semantics June 2005 Authors' Addresses Gonzalo Camarillo Ericsson Hirsalantie 11 Jorvas 02420 Finland EMail: Gonzalo.Camarillo@ericsson.com Jonathan Rosenberg Cisco Systems 600 Lanidex Plaza Parsippany, NJ 07054 US EMail: jdrosen@cisco.com Camarillo & Rosenberg Standards Track [Page 6]
RFC 4091 ANAT Semantics June 2005 Full Copyright Statement Copyright (C) The Internet Society (2005). This document is subject to the rights, licenses and restrictions contained in BCP 78, and except as set forth therein, the authors retain all their rights. This document and the information contained herein are provided on an "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Intellectual Property The IETF takes no position regarding the validity or scope of any Intellectual Property Rights or other rights that might be claimed to pertain to the implementation or use of the technology described in this document or the extent to which any license under such rights might or might not be available; nor does it represent that it has made any independent effort to identify any such rights. Information on the procedures with respect to rights in RFC documents can be found in BCP 78 and BCP 79. Copies of IPR disclosures made to the IETF Secretariat and any assurances of licenses to be made available, or the result of an attempt made to obtain a general license or permission for the use of such proprietary rights by implementers or users of this specification can be obtained from the IETF on-line IPR repository at http://www.ietf.org/ipr. The IETF invites any interested party to bring to its attention any copyrights, patents or patent applications, or other proprietary rights that may cover technology that may be required to implement this standard. Please address the information to the IETF at ietf- ipr@ietf.org. Acknowledgement Funding for the RFC Editor function is currently provided by the Internet Society. Camarillo & Rosenberg Standards Track [Page 7]

   

[Home] [Full RFC index] [RFC humour] [Our technology]

Copyright © Inter-Corporate Computer & Network Services, Inc.  All rights reserved.
All trademarks and RFC contents are the property of their respective owners.